 |
 |
 |
|
|
|
[Sponsors] | ||||
[ICEM] Mesh refinement in a cylindrical geometry |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 15, 2018, 08:39
|
Mesh refinement in a cylindrical geometry
|
#1 |
|
New Member
Somashekhar Kulkarni
Join Date: Oct 2017
Posts: 14
Rep Power: 8  |
I'm trying to refine the mesh inside a cylinder like geometry. The 3D blocking was produced by converting the mapped 2D surface blocking using the multizone method. I've tried using a density box spanning from the inlet to some height above the inlet but in vain. How do I go about it?
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Multi Region Mesh of a car filter | Zephiro88 | OpenFOAM Meshing & Mesh Conversion | 3 | September 11, 2019 19:34 |
| [snappyHexMesh] Error snappyhexmesh - Multiple outside loops | avinashjagdale | OpenFOAM Meshing & Mesh Conversion | 53 | March 8, 2019 09:42 |
| [snappyHexMesh] Number of cells in mesh don't match with size of cellLevel | colinB | OpenFOAM Meshing & Mesh Conversion | 14 | December 12, 2018 08:07 |
| [snappyHexMesh] Bad/jagged mesh around intersection of two .stl bodies | MBttR | OpenFOAM Meshing & Mesh Conversion | 7 | October 14, 2016 03:57 |
| [snappyHexMesh] SnappyHexMesh no layers and no decent mesh for complex geometry | pizzaspinate | OpenFOAM Meshing & Mesh Conversion | 1 | February 25, 2015 07:05 |
Linear Mode
