|March 20, 2016, 19:21||
"Uncovered faces" when refining
Join Date: May 2015
Posts: 5Rep Power: 3
I am meshing an 2D Pipe Junction in ICEM. I had no problems when I did the tutorial but when I tried to refining the mesh in one block (blocking>Pre-mesh params>Refinement (level 2)) I get the error that is shown in the picture.
I created a new subset as the message says but Fluent can't open the mesh...
Does Anyone know how to solve it?
Last edited by smb; March 21, 2016 at 05:37.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Refining only a portion of a mesh||wagnerzs||OpenFOAM||0||June 24, 2014 09:46|
|snappyHexMesh not refining surfaces||Hydro1004||OpenFOAM||3||August 29, 2012 11:56|
|Refining mesh along an edge at an intersection ?||mmn1239||STAR-CCM+||5||April 11, 2012 14:39|
|[ANSYS Meshing] "uncovered faces"||CRT||ANSYS Meshing & Geometry||6||March 23, 2012 12:38|
|Refining mesh||Atholl||FLUENT||2||February 19, 2002 07:38|