 |
 |
 |
|
|
|
[Sponsors] | ||||
May 5, 2016, 17:44
|
Ansys meshing problem
|
#1 |
|
Member
behzad Ghasemi
Join Date: Sep 2013
Location: Iran
Posts: 56
Rep Power: 12  |
Hi dear forumers,
I want to mesh a cubic cavity with a thin region in it. I defined nodes and edges then parted the cub in 8 sections to define surface and perform a mapped mesh. I did not use sketch method because it's not produce desired mapped mesh around thin region. problem arises when i import mesh in fluent and it assumes that section lines are wall. how can i solve this problem? Geometry pictures are attached. Thanks in advance 2.PNG Capture1.PNG |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 10:49 |
| Mesh difference between 14.5 version and 15.0 version in ansys meshing | sunxihui | ANSYS Meshing & Geometry | 0 | May 6, 2014 04:22 |
| [ANSYS Meshing] Problem with ANSYS Meshing - how to refine? | pyroknife | ANSYS Meshing & Geometry | 2 | August 22, 2013 13:30 |
| [ANSYS Meshing] Meshing Problem in worbench | elina | ANSYS Meshing & Geometry | 0 | March 31, 2013 08:53 |
| [Other] Ansys meshing airfoil and / or compressor blades | baw192 | ANSYS Meshing & Geometry | 8 | September 23, 2011 00:43 |
Linear Mode
