 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] can I subtract pieces from mesh |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 18, 2016, 08:39
|
can I subtract pieces from mesh
|
#1 |
|
Senior Member
Join Date: May 2012
Location: Melbourne
Posts: 161
Rep Power: 13  |
Hi, can I cut slots from a sweeped mesh?
this picture is before |
|
|
|
|
|
May 18, 2016, 08:40
|
|
#2 |
|
Senior Member
Join Date: May 2012
Location: Melbourne
Posts: 161
Rep Power: 13 |
and this how it should be
so instead of joining bits in ICEM, make the sweep first and then remove parts of the mesh |
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
| decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
| [snappyHexMesh] Multi Region Mesh of a car filter | Zephiro88 | OpenFOAM Meshing & Mesh Conversion | 3 | September 11, 2019 19:34 |
| [ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
| [ICEM] Problem making structural mesh on a surface | froztbear | ANSYS Meshing & Geometry | 1 | November 10, 2011 08:52 |
Linear Mode
