How to set inflation layer?
2 Attachment(s)
Hello everyone,
While doing my final project which consists on simulating the flow around a parabolic dish anttena I "found" a problem with the meshing. I did the geometry with inventor and I exported to ansys, then I create an enclosure, but I don't know how to create the appropiate mesh. My problems are: 1-The way I did the geometry is the good way? 2-Can I create inflation layer only in the zone I want and how? 3-Is posible not to mesh the interior part of the antenna? Thank you very much for your help. |
All times are GMT -4. The time now is 05:45. |