 |
 |
 |
|
|
|
[Sponsors] | ||||
[DesignModeler] add two area around Cylinder in ansys |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 23, 2016, 13:42
|
add two area around Cylinder in ansys
|
#1 |
|
New Member
S.cheraghian
Join Date: May 2016
Posts: 7
Rep Power: 11  |
In Ansys-APDL media, we can add two areas with Add instruction. So in non-Cylindrical volumes we add many areas easily too. But in Cylindrical Volumes we have to changing WP to add sidelong areas.
Now my question is : How can we do it? it means How can we add two areas around a Cylinder or around of any Cylindrical volumes? And What changes must be do in WP system? |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to use UDF to obtain the thred of the interface between the liquid and the wall? | hellowqy | Fluent UDF and Scheme Programming | 8 | December 17, 2015 11:03 |
| flow over a cylinder urgent! | kevin | FLUENT | 8 | August 11, 2015 14:00 |
| [ANSYS Meshing] uniform mesh, cylinder with a cut | Matiasi | ANSYS Meshing & Geometry | 5 | June 8, 2015 16:08 |
| Incorrect Drag and Drag Coefficient for flow over a cylinder | ozzythewise | Main CFD Forum | 8 | June 13, 2012 07:24 |
| [blockMesh] Specifying boundary faces failes in blockMesh | blaise | OpenFOAM Meshing & Mesh Conversion | 0 | May 10, 2010 04:56 |
Linear Mode
