 |
 |
 |
|
|
|
[Sponsors] | ||||
June 24, 2016, 23:16
|
ICEM 3d meshing problem
|
#1 |
|
New Member
Mahmoud
Join Date: Mar 2015
Posts: 16
Rep Power: 12  |
hi , everyone
i'm working on tip clearance of compressor cascade , i faced a problem with meshing of tip clearance size i made the 2d cascade meshing of 5 blades  then , extruded this meshing to make 3d mesh , here i faced the problem  i wanna make the same meshing along the span of blades but at the zone of tip clearance the meshing must be changed and this is the problem in addition to the higher increase of aspect ratio thanks advanced to everyone |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] ICEM Meshing problem | drvincentip | ANSYS Meshing & Geometry | 1 | May 2, 2013 17:31 |
| [ICEM] Problem with ICEM Script Meshing | asal | ANSYS Meshing & Geometry | 2 | March 23, 2013 19:11 |
| [ICEM] ICEM meshing problem | xyq102296 | ANSYS Meshing & Geometry | 6 | October 28, 2010 10:09 |
| [ICEM] Meshing problem from ICEM CFD to Fluent | cfdonlinederafa | ANSYS Meshing & Geometry | 2 | September 21, 2010 16:16 |
| ICEM meshing problem | Forrest | CFX | 4 | May 25, 2005 18:37 |
Linear Mode
