[ICEM] mesh quality -- CFD Online Discussion Forums

July 4, 2016, 03:26	mesh quality	#1
mohammad Senior Member mohammad Join Date: Dec 2010 Location: UK Posts: 245 Rep Power: 16	Hello everyone, Does anyone know about the exact equation through which the HEXA mesh quality is calculated? I am aware that the manual says that: The quality is a weighted diagnostic between Determinant (between -1 and 1), Max Orthogls (normalized between -1 and 1; if deviation from orthogonality is greater than 90 degrees, then the normalized value will be smaller than 0) and Max Warpgls (normalized between 0 and 1; warpage of 0 degrees is 1, warpage of 180 degrees is 0). The minimum of the 3 normalized diagnostics will be used. but my question is the weighted fuction. TNX

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] No layers in a small gap	bobburnquist	OpenFOAM Meshing & Mesh Conversion	6	August 26, 2015 09:38
Polyhedral Mesh Quality in Star-CCM+	niazaliahmed	STAR-CCM+	3	March 8, 2012 13:51
[ICEM] Tetra mesh quality before and after prism layer	Chander	ANSYS Meshing & Geometry	0	December 25, 2011 22:04
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 18:10

All times are GMT -4. The time now is 11:07.