ICEMCFD "ogrid not successful" error
1 Attachment(s)
Hello, I'm new to icemcfd.
I drew the model and i transferred ICEM CFD. There is no gap. i associated edge to curve and then i want to ogrid block but i didn't this. I sent in additional error screenshot |
it should work. did you use option around? did you make splits around your body first??
|
1 Attachment(s)
Yes i used around option and i splitted body
i sent wrong picture sorry |
dont delete the inner block before creating ogrid
|
i didn't delete any body. before start icemcfd, i did boolean and i subtracted face so there was a gap below.
this could be caused? |
All times are GMT -4. The time now is 13:25. |