 |
 |
 |
|
|
|
[Sponsors] | ||||
[Workbench] Preparing mathematical model and solving mathematical model stuck |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 4, 2016, 04:56
|
Preparing mathematical model and solving mathematical model stuck
|
#1 |
|
New Member
Join Date: Aug 2016
Posts: 1
Rep Power: 0  |
Hey,
So I am running an analysis on a blade and disc geometry. The mesh has been generated and I am now solving for a solution. The Workbench Solution Status keeps going from preparing the mathematical model to solving the mathematical then back. The overall progress bar doesn't seem to be progressing. I'd just like to confirm if this is a regular issue and I should just wait patiently for full analysis to run, or if there is some form is issue here I am not picking up on? Hope you can help. |
|
|
|
|
|
August 10, 2016, 03:29
|
|
#2 |
|
Senior Member
Join Date: Apr 2014
Location: Melbourne
Posts: 584
Rep Power: 15 |
has it run in last 6 days?
|
|
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| simpleFoam error - "Floating point exception" | mbcx4jc2 | OpenFOAM Running, Solving & CFD | 12 | August 4, 2015 03:20 |
| Unstabil Simulation with chtMultiRegionFoam | mbay101 | OpenFOAM Running, Solving & CFD | 13 | December 28, 2013 14:12 |
| pimpleFoam: turbulence->correct(); is not executed when using residualControl | hfs | OpenFOAM Running, Solving & CFD | 3 | October 29, 2013 09:35 |
| pisoFoam with k-epsilon turb blows up - Some questions | Heroic | OpenFOAM Running, Solving & CFD | 26 | December 17, 2012 04:34 |
| Differences between serial and parallel runs | carsten | OpenFOAM Bugs | 11 | September 12, 2008 12:16 |
Linear Mode
