Automatic Geo/Meshing Help
 

Hello everyone,

For a project I am working on I am required to run though a large number of simple cases (100+).

So I was wondering, if anyone could point me in a good direction with how to do automatic geometry creation and meshing in ANSYS Workbench.

If it helps: It is a very simple geometry (almost just a beam) Only 1 or 2 dimensions would have to change each time.

Thanks!

I have done a bunch more research on it and really can not find anything on it. If anyone could even just point me in a right direction or give some simple advice it would be much appreciated!