Long pipe, longitudinal inflation
Hi!
I'm working in a long pipe, I've developed an O-Grid for it, so that the cross section has a proper mesh, but now I want it to have a longitudinal inflation in one specific direction (X direction). How could I do this? |
Hello Sebastián,
I assume you have generated a blocking (structured mesh). Then, this should be easily done by setting edge param(eter)s on edges aligned with x direction. Have a look under Blocking->Pre-Mesh-Param->Edge Param. Check the help for more information. I suggest you to do some tutorials of icem provided in the tutorial guide, start with "Hexa Mesh Generation for a 2D Pipe Junction" With regards, Sebastian |
Thanks a lot! This was exactly what I was looking for!
|
All times are GMT -4. The time now is 01:35. |