[DesignModeler] meshing problem

sunjian · August 23, 2016, 22:34

hi,everyone
i'm new to ansys DesignModeler and meshing. i simulated a pipe with deflectors inside. In DesignModeler, i used Sweep feature to make the deflectors in the pipe. Then in ansys meshing, the mesh was made without any problems. But when i imported the mesh file into Fluent, the deflectors in the pipe were missing. Does anyone know the reason why this happened? i couldn't upload the images. So the problem maybe abstract. i appreciate you guys give some suggestions.
Thank you in advance.

sunjian · August 23, 2016, 23:03

pipe1.jpg

test2.jpg

test3.jpg
i uploaded images. i think this will make the problem more understandable.

August 23, 2016, 22:34	meshing problem	#1
sunjian New Member Join Date: Jun 2014 Posts: 16 Rep Power: 11	hi,everyone i'm new to ansys DesignModeler and meshing. i simulated a pipe with deflectors inside. In DesignModeler, i used Sweep feature to make the deflectors in the pipe. Then in ansys meshing, the mesh was made without any problems. But when i imported the mesh file into Fluent, the deflectors in the pipe were missing. Does anyone know the reason why this happened? i couldn't upload the images. So the problem maybe abstract. i appreciate you guys give some suggestions. Thank you in advance.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with querying the meshing database in CFX-Pre	ashtonJ	CFX	18	April 18, 2023 23:49
[Other] Hex meshing problem DM12	patrick	ANSYS Meshing & Geometry	7	January 9, 2015 07:21
[ANSYS Meshing] Inflation - Airfoil Meshing - Divergence problem	dalecooper	ANSYS Meshing & Geometry	0	July 19, 2013 07:04
Meshing problem in GAMBIT	Vidya Raja	FLUENT	0	May 20, 2006 23:31
GAMBIT meshing problem	Gauthier Lambert	Main CFD Forum	1	August 3, 2000 09:22

August 23, 2016, 23:03		#2
sunjian New Member Join Date: Jun 2014 Posts: 16 Rep Power: 11	pipe1.jpg test2.jpg test3.jpg i uploaded images. i think this will make the problem more understandable.