 |
 |
 |
|
|
|
[Sponsors] | ||||
August 23, 2016, 08:20
|
3d wing hex mesh
|
#1 |
|
New Member
bryan
Join Date: Aug 2016
Posts: 2
Rep Power: 0  |
Hello everybody,
I try to generate a 3d wing mesh with ansys meshing. First I meshed the wing with tetrahedron methods according to cornell's tutorial but when I did mesh its orthogonal and skewness quality were bad. It was not in acceptable region especially trailing edge and wing tip. So I tried hex mesh using multizone method with inflation but i didn't achive mesh. Could you help me how can I achive hex mesh for wing and which mesh strategy should I apply? |
|
|
|
|
|
August 24, 2016, 03:02
|
|
#2 |
|
New Member
bryan
Join Date: Aug 2016
Posts: 2
Rep Power: 0 |
Nobody can help?
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OpenFOAM] ParaView shows bad cells, checkMesh doesn't seem to notice. | CoolHand | ParaView | 2 | August 21, 2014 16:58 |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 07:20 |
| 3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 07:42 |
| [ANSYS Meshing] Creating Hex Boundary Layer Mesh and Unstructured everywhere else | NLao | ANSYS Meshing & Geometry | 1 | March 15, 2011 07:35 |
| Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 15:09 |
Linear Mode
