|
[Sponsors] |
[DesignModeler] Import from NX, Parameters and Named Selections are Missing |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 15, 2016, 04:34 |
Import from NX, Parameters and Named Selections are Missing
|
#1 |
New Member
CW
Join Date: Jan 2015
Posts: 4
Rep Power: 11 |
Hi,
I am attempting to insert a geometry into WB from NX while keeping parameters. Similar to http://www.ansys-blog.com/create-ans...selections-nx/ However when I do, no parameters are able to be found and no name selections either. I have the set the correct filters for both. I have tried selecting 'Independent' and 'All' for parameters (Im using 17.1 and it is not just a check) and still no luck. I have defined my parameters in the expressions tool in NX and my named selections in the NS Manager as well. Any help as to why I cannot import my parameters and named selections? |
|
September 15, 2016, 06:43 |
Solved
|
#2 |
New Member
CW
Join Date: Jan 2015
Posts: 4
Rep Power: 11 |
After hours of trying to figure out what was causing this I solved it by running CAD Configuration Manger. Before, I assumed I wouldnt need to run it as it was importing the CAD fine.
|
|
September 15, 2016, 19:28 |
|
#3 |
Senior Member
Join Date: Apr 2014
Location: Melbourne
Posts: 584
Rep Power: 14 |
if you are only importing geometry then you can dont need CAD configuration manager but if you want to import parameters and NS then you do need to have connection between two!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Generate Parts Using Named Selection | jonasohlsson | ANSYS | 1 | March 14, 2016 04:32 |