CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

ICEM CFD and Fluent

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   April 16, 2019, 08:35
Question single edge ICEM
  #1
New Member
 
FengPengyu
Join Date: Apr 2019
Posts: 1
Rep Power: 0
rainst is on a distinguished road
Hello everybody,
Recently, I completed the grid division of proton exchange membrane fuel cells in ICEM CFD. single edge and uncovered face problems occurred during grid inspection. after the uncovered face problem was automatically fixed, separating wall and removing unreferenced faces appeared after the grid was imported into Fluent.
thank you all,
rainst.

Last edited by rainst; April 18, 2019 at 22:11.
rainst is offline   Reply With Quote

Reply

Tags
separating wall, single edge, unreferenced face

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
[TurboGrid] turbogrid to icem cfd then icem cfd to fluent tmeysam92 ANSYS Meshing & Geometry 0 May 7, 2014 07:25
Export mesh from ICEM CFD for Fluent summerdream ANSYS 2 September 10, 2013 13:12
Transport mesh from ICEM CFD, to Fluent, to Sysnoise Wieland FLUENT 2 April 15, 2012 07:28
Dimension conflict between icem cfd and fluent highhopes ANSYS Meshing & Geometry 1 September 9, 2011 12:07
[ICEM] Export unstructured periodic mesh from ICEM CFD to Fluent ivanddd ANSYS Meshing & Geometry 1 February 3, 2011 01:51


All times are GMT -4. The time now is 07:02.