[ANSYS Meshing] Mesh did not appear when number of nodes were specified along a curve -- CFD Online Discussion Forums

November 13, 2016, 03:43	Mesh did not appear when number of nodes were specified along a curve	#1
davidwilcox Senior Member david Join Date: Oct 2012 Posts: 142 Rep Power: 13	Hi, I am meshing a blade with unstructured grids. As we all know, the trailing edge issues can be solved by using thin-cuts. I did this with an edge criterion of 0.2. However, i left the the number of the nodes on the trailing edge line blank. the mesh comes out nice but the trailing edge was a little coarse. When I specified the number of nodes on the trailing edge line and remeshed, the mesh of the blade did not appear. Is there a way around this?

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
simpleFoam parallel	AndrewMortimer	OpenFOAM Running, Solving & CFD	12	August 7, 2015 18:45
[ICEM] Hexa mesh, curve mesh setup, bunching law	Anorky	ANSYS Meshing & Geometry	4	November 12, 2014 00:27
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 06:20
Cluster ID's not contiguous in compute-nodes domain. ???	Shogan	FLUENT	1	May 28, 2014 15:03
AMI interDyMFoam for mixer	danny123	OpenFOAM Running, Solving & CFD	4	June 19, 2013 04:49

All times are GMT -4. The time now is 08:26.