 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] Mashing one face of a body only |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 13, 2016, 06:39
|
Mashing one face of a body only
|
#1 |
|
New Member
Join Date: Mar 2016
Posts: 2
Rep Power: 0  |
Hi, i have searched but did not find the answer on the forums or help files. I am trying to mesh the curved part of a cylinder but not the flat faces - i am following a tutorial but this step is not shown. I include a picture below of what i need. Any help will be gratefully appreciated. Thank you
|
|
|
|
|
|
December 13, 2016, 08:50
|
|
#2 |
|
Senior Member
Onur Özcan
Join Date: Feb 2016
Location: Istanbul/Turkey
Posts: 461
Rep Power: 12 |
that is a surface mesh. click face you want to make mesh and right click to make surface mesh. All are in meshing screen
|
|
|
|
|
|
|
December 13, 2016, 09:54
|
|
#3 |
|
New Member
Join Date: Mar 2016
Posts: 2
Rep Power: 0 |
Thank you for your response, its much appreciated.
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [DesignModeler] Smaller surface body from face | bongbang | ANSYS Meshing & Geometry | 1 | June 29, 2015 02:28 |
| snappyhexmesh remove blockmesh geometry | philipp1 | OpenFOAM Running, Solving & CFD | 2 | December 12, 2014 10:58 |
| [blockMesh] non-orthogonal faces and incorrect orientation? | nennbs | OpenFOAM Meshing & Mesh Conversion | 7 | April 17, 2013 05:42 |
| channelFoam for a 3D pipe | AlmostSurelyRob | OpenFOAM | 3 | June 24, 2011 13:06 |
| (gambit)projecting just a part of mesh on another face? | gholamghar | ANSYS Meshing & Geometry | 2 | March 14, 2011 17:14 |
Linear Mode
