 |
 |
 |
|
|
|
[Sponsors] | ||||
December 18, 2016, 18:17
|
Meshing Hundreds of Shells
|
#1 |
|
New Member
Yang
Join Date: Jun 2015
Posts: 25
Rep Power: 10  |
https://postimg.org/image/rvfl7cuxp/
Received an IGES file of a pack of grains/crystals that I need to simulate. Imported in DM and turns out to be a ton of shells. Where do I start? Do I need to worry about all the intersections and solidify? Is there a method of getting one solid part from a bunch of intersecting solid parts? Also, is it possible to make all the edges round? End goal is I want to apply a force at one point with the "bottom" part constrained. Also might use Fluent over the "top" surface. Last edited by yow; December 18, 2016 at 22:06. |
|
|
|
|
|
December 18, 2016, 22:02
|
|
#2 |
|
Senior Member
Join Date: Apr 2014
Location: Melbourne
Posts: 584
Rep Power: 14 |
not able to see the attached pic
|
|
|
|
|
|
|
December 18, 2016, 22:06
|
|
#3 |
|
New Member
Yang
Join Date: Jun 2015
Posts: 25
Rep Power: 10 |
Updated; thanks. I got it to work. Turns out if the grains/crystals are slightly more spread apart, the CAD model has no trouble exporting the structure as a single part STL file.
Last edited by yow; December 19, 2016 at 00:23. |
|
|
|
|
|
 |
| Tags |
| boolean, intersecting geometry, merge, shell, surface patch |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] only automatic meshing works, | kazra | ANSYS Meshing & Geometry | 2 | February 23, 2017 11:38 |
| [Gmsh] 3D coil mesh: can't create the volume? | RomainBou | OpenFOAM Meshing & Mesh Conversion | 3 | July 18, 2016 05:09 |
| [Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 10:49 |
| Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |
Linear Mode
