 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] partwise meshing over a face with two partition |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 14, 2017, 16:51
|
partwise meshing over a face with two partition
|
#1 |
|
Member
saurabh kumar gupta
Join Date: Jul 2016
Location: kanpur,india
Posts: 53
Rep Power: 11  |
Hi All,
i am new to CFD. i need to mesh a body which has a partition over its face.when i am selecting any of the faces it is fine and able to select any of them. but when meshing only single mesh is being generated. i want to know how can i generate tri mesh on one side and tetra on other side. thanks saurabh |
|
|
|
|
|
| Tags |
| partition, tetra mesh, tri mesh, zonemesh |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Error snappyhexmesh - Multiple outside loops | avinashjagdale | OpenFOAM Meshing & Mesh Conversion | 53 | March 8, 2019 10:42 |
| [blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 10:56 |
| [ICEM] how to define periodic for free type face in hexa meshing | mingersai | ANSYS Meshing & Geometry | 0 | February 5, 2012 02:55 |
| Singularity of grid?Volume meshing vs face meshing | Ken | Main CFD Forum | 0 | September 4, 2003 12:09 |
| Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 12:08 |
Linear Mode
