|
[Sponsors] |
[ANSYS Meshing] Multizone source face detected failure |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 28, 2017, 18:45 |
Multizone source face detected failure
|
#1 |
New Member
Joyce
Join Date: Jun 2016
Posts: 5
Rep Power: 9 |
Hello all,
My mesh is a large domain with two tubes inside it, and they are different domains. So I want to use multizone to simulate the outer large domain, and I selected the face without two tubes as the source face (Fig.source face), but the meshing result seems to ignore the two tubes (Fig.multizone). It seems that the face size is too large to detect the locations of two tubes, but no matter how I decrease the min size, it doesn't work. Do you guys have any ideas what should I do to deal with it? Thank you! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
[swak4Foam] funkyDoCalc with OF2.3 massflow | NiFl | OpenFOAM Community Contributions | 14 | November 25, 2020 03:30 |
"parabolicVelocity" in OpenFoam 2.1.0 ? | sawyer86 | OpenFOAM Running, Solving & CFD | 21 | February 7, 2012 11:44 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |