 |
 |
 |
|
|
|
[Sponsors] | ||||
March 3, 2017, 08:59
|
Points to sketch
|
#1 |
|
New Member
Eszter Dudas
Join Date: Mar 2017
Posts: 1
Rep Power: 0  |
Hi everyone,
I'm quite new here, but the last few days I can't find a solution for inserting my points (list of coordinates x,y,z) into Design Modeler as base of Sketch. I mean I have points of a profile (98 points) and I want them to use as base of sketch in order to complete my nozzle. From the sketch later I would like to make a surface and then start to make my calculations. However, if I read it like Create/Points/from cooordinates they will appear but not as something that I could use as sketch. Any ideas?? |
|
|
|
|
 |
| Tags |
| points data file, sketch design modeler, surface area |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
| [snappyHexMesh] crash sHM | H25E | OpenFOAM Meshing & Mesh Conversion | 11 | November 10, 2014 11:27 |
| [DesignModeler] DM's JScript: FPoint()'s GetPoint(i) function picks points backwards? | ANT | ANSYS Meshing & Geometry | 2 | July 23, 2012 15:25 |
| [DesignModeler] points defined by coordinates in sketch (design modeler) | Laurence Wallian | ANSYS Meshing & Geometry | 2 | February 1, 2012 02:10 |
| [blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
Linear Mode
