|
[Sponsors] |
April 20, 2017, 23:05 |
inflation of curved geometry
|
#1 |
New Member
|
Dear all, I would like to seek advice from you all how to create an inflation of a curved geometry. As you see from the attached, the right side is inflated nicely while the left side cannot be inflated at all. Can you please advise ?
Thanks Ariff |
|
April 25, 2017, 18:53 |
|
#2 |
Senior Member
Join Date: Apr 2014
Location: Melbourne
Posts: 584
Rep Power: 14 |
suggest you to do separate named selection and give inflation separately for both
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Inflation Layer Meshing around a Corner of two different connected Geometry | andon6141 | ANSYS Meshing & Geometry | 1 | June 2, 2015 08:30 |
[ANSYS Meshing] Inflation on chine hull Geometry | shzinwoyk | ANSYS Meshing & Geometry | 3 | March 20, 2015 07:55 |
Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 19:42 |
vitual _ real | deneb | FLUENT | 3 | January 22, 2007 04:31 |
Inflation | Gab | CFX | 6 | August 24, 2005 22:45 |