[ICEM] ICEM CFD meshing lock edge mesh size

vickyiamlucky · April 28, 2017, 09:25

i am having trouble that if i change mesh size near inlet (even without switching on copy parameters), the mesh size near output edge changes and viceversa.. occurs in outlet side meshing...

so i was able to get good mesh near inlet or outlet....

i like to mention also that there are some other blocks of different structures inbetween. then how the inlet and outlet edge interlinked.....

is there a way to lock one end edge mesh size and do the other......

please give certain idea thank u for any reply....

vickyiamlucky · April 28, 2017, 09:27

i am having trouble that if i change mesh size near inlet (even without switching on copy parameters), the mesh size near output edge changes and viceversa.. occurs in outlet side meshing...

so i was able to get good mesh near inlet or outlet.... but not on both side of 3d meshing

i like to mention also that there are some other blocks of different structures inbetween. then how the inlet and outlet edge interlinked.....

is there a way to lock one end edge mesh size and do the other......

please give certain idea thank u for any reply....

April 28, 2017, 09:25	ICEM CFD meshing lock edge mesh size	#1
vickyiamlucky New Member vigneshwaran Join Date: Apr 2017 Posts: 5 Rep Power: 10	i am having trouble that if i change mesh size near inlet (even without switching on copy parameters), the mesh size near output edge changes and viceversa.. occurs in outlet side meshing... so i was able to get good mesh near inlet or outlet.... i like to mention also that there are some other blocks of different structures inbetween. then how the inlet and outlet edge interlinked..... is there a way to lock one end edge mesh size and do the other...... please give certain idea thank u for any reply....

April 28, 2017, 09:27	correction for better understanding	#2
vickyiamlucky New Member vigneshwaran Join Date: Apr 2017 Posts: 5 Rep Power: 10	i am having trouble that if i change mesh size near inlet (even without switching on copy parameters), the mesh size near output edge changes and viceversa.. occurs in outlet side meshing... so i was able to get good mesh near inlet or outlet.... but not on both side of 3d meshing i like to mention also that there are some other blocks of different structures inbetween. then how the inlet and outlet edge interlinked..... is there a way to lock one end edge mesh size and do the other...... please give certain idea thank u for any reply....

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
multi-body meshing with ICEM CFD	Espilet	ANSYS Meshing & Geometry	0	September 19, 2015 16:49
[Gmsh] Vertex numbering is dense	KateEisenhower	OpenFOAM Meshing & Mesh Conversion	7	August 3, 2015 11:49
[snappyHexMesh] crash sHM	H25E	OpenFOAM Meshing & Mesh Conversion	11	November 10, 2014 12:27
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55
How to control Minximum mesh space?	hung	FLUENT	7	April 18, 2005 10:38