|
[Sponsors] |
May 25, 2017, 15:53 |
name of the dimensions
|
#1 |
New Member
Codemania34@yahoo.com
Join Date: May 2017
Posts: 13
Rep Power: 8 |
I would like to ask about naming of the dimension in Ansys Geometry Engine i.e DesignModeler.
I have created a circle and assigned a diameter it a few times. Now there is only one diameter on it but its name is D4. How can I change it to D1. This is very strange for me. Thank you. |
|
May 25, 2017, 22:29 |
|
#2 |
Senior Member
Svetlana Tkachenko
Join Date: Oct 2013
Location: Australia, Sydney
Posts: 407
Rep Power: 14 |
These names are assigned automatically and you can not change them. Please ignore them (or if the naming is essential for some reason then stop deleting them but this is not the intended usage).
The same naming scheme is used for operations, for example booleans or slices, as well as in other ANSYS products. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
contact angle behavior in micro & nano dimensions | Jimbomet | OpenFOAM Running, Solving & CFD | 7 | June 18, 2016 17:18 |
FOAM FATAL ERROR for Different dimensions | rupesh_w | OpenFOAM Running, Solving & CFD | 2 | April 27, 2016 05:14 |
Incompatible dimensions for operation | ruben23 | OpenFOAM Running, Solving & CFD | 2 | June 12, 2015 05:14 |
Software that can stretch the overall dimensions of a mesh. | Robert_B | Main CFD Forum | 2 | January 27, 2012 08:39 |
Different dimensions for FATAL ERROR | retech | OpenFOAM Running, Solving & CFD | 2 | August 14, 2007 11:17 |