How to create adapated mesh in ICEM
I am looking to create following kind of mesh to maintain wall-normal and wall-prallel spacing near the wall.
How to create following kind of mesh https://dl.dropbox.com/s/mskkp7kjf7z...pture.PNG?dl=0 |
To the best of my knowledge, it is not possible to create this kind of mesh with ansys tools. Neither ICEM nor Ansys Meshing.
|
I'm not sure but as I remember Fluent was able to adapt mesh in that way during the calculation. Maybe Fluent Mesher is able to compute boundary layer like these.
|
See if this helps. It's called a hanging point mesh adaptation.
http://www.afs.enea.it/project/neptu...ug/node869.htm |
its possible. refine block and multiply by factor from bottom to top
|
All times are GMT -4. The time now is 00:18. |