 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] project faces changes near wall cell distribution |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 21, 2017, 07:25
|
project faces changes near wall cell distribution
|
#1 |
|
New Member
Ben
Join Date: Mar 2013
Posts: 15
Rep Power: 12  |
Hi,
I've recently started using ICEM 17 (17.1 and 17.2) and have run into a problem that I can't fix. I have a simple 2D mesh for the forward facing step. I have found that I will need a first cell height of 1.5e-06 to get the desired y+. When I compute the pre-mesh with the options 'project faces/edges' the cell distribution close to some of the edges is not giving me the desired 1.5e-06, it is too big. Is there some kind of setting which fixes the minimum cell height at some edges? I have attached a figure to show what is happening. Point A has the correct cell height (to the left of the step) however at point B the cell height along the x axis will not reduce to 1.5e-06 as specified. Thanks for any help you can give me. |
|
|
|
|
|
| Tags |
| ansys 17.0, icem 17, meshing 2d |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Error snappyhexmesh - Multiple outside loops | avinashjagdale | OpenFOAM Meshing & Mesh Conversion | 53 | March 8, 2019 09:42 |
| [snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
| Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam) | cfdonline2mohsen | OpenFOAM | 3 | October 21, 2013 09:28 |
| DecomposePar unequal number of shared faces | maka | OpenFOAM Pre-Processing | 6 | August 12, 2010 09:01 |
| Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |
Linear Mode
