|
[Sponsors] |
July 26, 2017, 01:34 |
Hexa meshing with dummy
|
#1 |
New Member
JungHo Lee
Join Date: Mar 2015
Posts: 20
Rep Power: 11 |
Hello, guys.
I'm currently make hexa mesh of a dummy which located in the indoor. The shape of dummy was shown in attached figure. The block was divided around dummy, and the hexa mesh was generated. However, the determinant of less than 0.3 was present, which shown in image 2. I tried to improve the mesh quality by moving vertex of block or making O-grid, but there are still less than 0.3 determinant hexa mesh. Is there any way to improve mesh quality in this case? Thank you. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Blocking for hexa meshing of diffuser augumented wind turbine | zeeshu | Mesh Generation & Pre-Processing | 0 | February 10, 2016 17:37 |
Blocking for hexa meshing of diffuser augumented wind turbine | zeeshu | ANSYS Meshing & Geometry | 1 | February 10, 2016 16:23 |
[ICEM] ICEM Hexa Meshing Automation | Haasini | ANSYS Meshing & Geometry | 1 | April 24, 2012 22:46 |
[ICEM] Meshing difficulties (Hexa meshing, O-Grid, etc.). Even possible to be resolved? | JasonLam | ANSYS Meshing & Geometry | 0 | April 19, 2011 20:08 |
[ICEM] Hexa Meshing a helical profile | Balakrshnan Ramakrishnan | ANSYS Meshing & Geometry | 1 | August 24, 2010 10:53 |