|
[Sponsors] |
[ANSYS Meshing] Inflation problem on curved region |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 14, 2017, 03:02 |
Inflation problem on curved region
|
#1 |
New Member
|
Dear all,
Please see my attached geometry. As you can see there, there is no inflation on the other side of the curve geometry. Please advise how to create inflation on that curve geometry. Many thanks. regards |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem with Min/max rho | tH3f0rC3 | OpenFOAM | 8 | July 31, 2019 09:48 |
[ANSYS Meshing] Inflation Layer Problem | pyroknife | ANSYS Meshing & Geometry | 0 | May 20, 2013 14:05 |
[ANSYS Meshing] Inflation layer _ Boundary Problem | elina | ANSYS Meshing & Geometry | 4 | March 31, 2013 08:47 |
Problem in setting porosity region for rhoPorousSimpleFoam | run_cfd | OpenFOAM Pre-Processing | 1 | May 31, 2011 09:02 |
[Other] StarToFoam error | Kart | OpenFOAM Meshing & Mesh Conversion | 1 | February 4, 2010 04:38 |