 |
 |
 |
|
|
|
[Sponsors] | ||||
[ICEM] 3D free bock mesh type with structured Hexa |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 9, 2017, 02:11
|
3D free bock mesh type with structured Hexa
|
#1 |
|
New Member
Sina
Join Date: Jun 2015
Posts: 7
Rep Power: 12  |
I meshed a building in a domain with the Hexa blocks method. There are holes in the building forming through-building openings. Now I need to change the mesh inside the hole to one of the free types such as "all tri","hex-dominant" and etc.. I converted the mapped to free and used "3D free block mesh type". I do not know how to construct the volume mesh now. When I check using the cut plane there are just surfaces that are meshed, not volume. Also, there are walls inside the hole that I want to use prism on them.
Can any one help me? Building:  Close-up: 
|
|
|
|
|
|
| Tags |
| free block type, hex dominant, hexa block, icem cfd |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 06:38 |
| [Commercial meshers] Mesh conversion problem (fluent3DMeshToFoam) | Aadhavan | OpenFOAM Meshing & Mesh Conversion | 2 | March 8, 2018 02:47 |
| Modified pimpleFoam solver to MRFPimpleFoam solver | hiuluom | OpenFOAM Programming & Development | 12 | June 14, 2015 22:22 |
| rhoReactingFoam error | shenzhou1987 | OpenFOAM Running, Solving & CFD | 3 | January 20, 2015 23:19 |
| singularity? | mihaipruna | OpenFOAM Running, Solving & CFD | 5 | April 24, 2012 18:18 |
Linear Mode
