Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[DesignModeler] Cutting out solid shapes

Mark Forums Read

Reply

Search this Thread

November 14, 2017, 14:35	Cutting out solid shapes	#1
bushrar New Member Bushra Join Date: Nov 2017 Posts: 2 Rep Power: 0	Hello, I was wondering if anyone knew how to cut out a diagonal section out of a cylinder on ANSYS Design Modeler, without using the section plane option? Thanks! Best, Bushra

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
conjugate heat transfer in OpenFOAM	skuznet	OpenFOAM Running, Solving & CFD	99	March 16, 2017 05:07
Error - Solar absorber - Solar Thermal Radiation	MichaelK	CFX	12	September 1, 2016 05:15
[swak4Foam] mass conservation of solid phase violated when using groovyBC with twoPhaseEulerFoam	xpqiu	OpenFOAM Community Contributions	8	June 17, 2015 02:08
Error finding variable "THERMX"	sunilpatil	CFX	8	April 26, 2013 07:00
CFX4.3 -build analysis form	Chie Min	CFX	5	July 12, 2001 23:19

All times are GMT -4. The time now is 06:08.