[ICEM] Converting 2D blocking to 3D -- CFD Online Discussion Forums

November 24, 2017, 02:23

Converting 2D blocking to 3D

somas123

New Member

Somashekhar Kulkarni

Join Date: Oct 2017

Posts: 14

Rep Power: 8

The geometry that I want to mesh is given in the picture below. I've created a surface block using the swept option in 2d surface blocking. The blocking is also shown in the attached image. The main issue that I am facing is in converting the surface block to a 3D block. I've tried using different techniques in the multizone fill option but in vain. Can anyone provide suggestions?

Attached Images

	test section.JPG (15.3 KB, 19 views)
	test section blocking.JPG (19.8 KB, 15 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Blocking technique. Issues of the day.	Zeppo	ANSYS Meshing & Geometry	16	June 14, 2020 09:56
[ICEM] Correct blocking and Ogrid in ICEM	salumi	ANSYS Meshing & Geometry	3	November 8, 2016 10:10
[ICEM] Converting or projecting Edge (of blocking) to generate curve	AshwaniAssam	ANSYS Meshing & Geometry	0	October 9, 2013 23:55
[ICEM] Problem to load the blocking	biasilveira	ANSYS Meshing & Geometry	2	February 24, 2013 22:04
[ICEM] Blocking and Symmetry	BrolY	ANSYS Meshing & Geometry	32	August 24, 2012 03:13

All times are GMT -4. The time now is 03:25.