CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[Workbench] error in meshing

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   November 25, 2017, 04:13
Default error in meshing
  #1
New Member
 
Siju simon
Join Date: Nov 2017
Posts: 18
Rep Power: 2
sijusimon is on a distinguished road
I Made a model of reinforced concrete beam column joint in ansys workbench. while solving the model, after giving all force and boundary condition, it shows following two errors:

error 1:
"The value of UZ at node 5073 is 6057083.95. It is greater than the
current limit of 1000000"
error 2:
"If one or more parts of the model are held together only by contact
verify that the contact surfaces are closed. Also make sure that
there are constraints (or friction) in the sliding direction even if
no load is applied in that direction"

how can i rectify these errors
sijusimon is offline   Reply With Quote

Old   November 26, 2017, 14:53
Default
  #2
Senior Member
 
Gweher's Avatar
 
Gwenael H.
Join Date: Mar 2011
Location: Switzerland
Posts: 251
Rep Power: 13
Gweher is on a distinguished road
Hi Simon,

The errors are clearly stated and suggestions are even provided... Obviously your model isn't properly defined. Try to address the issue by constraining the model. Moreover you can highlight the problematic nodes by selecting the mesh id.
Gweher is offline   Reply With Quote

Old   November 26, 2017, 21:25
Default
  #3
New Member
 
Siju simon
Join Date: Nov 2017
Posts: 18
Rep Power: 2
sijusimon is on a distinguished road
Thank you.
sijusimon is offline   Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
[ANSYS Meshing] Can start ANSYS meshing only one time on ubuntu 16.04 Touré ANSYS Meshing & Geometry 2 September 26, 2017 05:41
[ANSYS Meshing] only automatic meshing works, kazra ANSYS Meshing & Geometry 2 February 23, 2017 11:38
[Gmsh / openFOAM] 3D coil mesh: can't create the volume? RomainBou Open Source Meshers: Gmsh, Netgen, CGNS, ... 3 July 18, 2016 05:09
[ANSYS Meshing] Can I use ANSYS Meshing for manual meshing? Kirjain ANSYS Meshing & Geometry 6 November 30, 2015 08:11
[gmsh] Vertex numbering is dense KateEisenhower Open Source Meshers: Gmsh, Netgen, CGNS, ... 7 August 3, 2015 10:49


All times are GMT -4. The time now is 01:12.