[ICEM] Double Pre-mesh

zenip · November 18, 2017, 08:55

Hi, after an error to import my mesh in Fluent :

(WARNING: Mesh has uncovered edges. ANSYS Fluent needs a complete boundary (lines in 2D) or it will give a variety of errors and not read in the mesh! If this was 2D Hexa, perhaps your edges are not associated with perimeter curves".
)

, i have done a mesh check and accept all the request.

Now i have a new problem, when i open my project i have the original mesh and when i click on pre-mesh i have a second mesh on the first one. How i can delete the last one ?

Thanks

Gweher · November 28, 2017, 06:46

Hi Vans,

You can simply unload the existing mesh > file > mesh > close mesh. Or when you convert your new pre-mesh, select > replace to overwrite the existing one.

Have fun

zenip · November 28, 2017, 13:51

Thanks a lot !!

Gweher · November 29, 2017, 07:11

You're welcome

November 18, 2017, 08:55	Double Pre-mesh	#1
zenip New Member Vans Join Date: Nov 2017 Posts: 5 Rep Power: 8	Hi, after an error to import my mesh in Fluent : (WARNING: Mesh has uncovered edges. ANSYS Fluent needs a complete boundary (lines in 2D) or it will give a variety of errors and not read in the mesh! If this was 2D Hexa, perhaps your edges are not associated with perimeter curves". ) , i have done a mesh check and accept all the request. Now i have a new problem, when i open my project i have the original mesh and when i click on pre-mesh i have a second mesh on the first one. How i can delete the last one ? Thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
Continuing User Defined Real Gas Model issues	aeroman	FLUENT	6	April 8, 2016 03:34
New densitybased solver AeroFoam	giulio_romanelli	OpenFOAM Running, Solving & CFD	48	January 15, 2016 08:20
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation	tommymoose	ANSYS Meshing & Geometry	48	April 15, 2013 04:24
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 18:10

November 28, 2017, 06:46		#2
Gweher Senior Member Gwenael H. Join Date: Mar 2011 Location: Switzerland Posts: 392 Rep Power: 20	Hi Vans, You can simply unload the existing mesh > file > mesh > close mesh. Or when you convert your new pre-mesh, select > replace to overwrite the existing one. Have fun

November 28, 2017, 13:51		#3
zenip New Member Vans Join Date: Nov 2017 Posts: 5 Rep Power: 8	Thanks a lot !!

November 29, 2017, 07:11		#4
Gweher Senior Member Gwenael H. Join Date: Mar 2011 Location: Switzerland Posts: 392 Rep Power: 20	You're welcome