 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] Bad Mesh Quality near the Body |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 1, 2017, 03:20
|
Bad Mesh Quality near the Body
|
#1 |
|
New Member
Join Date: Nov 2017
Posts: 1
Rep Power: 0  |
Hello,
I want to simulate the flow past a Diffusor. But I had some problems with meshing. My mesh quality near my body is bad. Skewness max 0.88 Orthogonal min 0.11 I had this problem with other geometry's too. Like Front or rear wing. Where is my mistake? How can I improve the Mesh quality in this area? Thanks in advance |
|
|
|
|
|
| Tags |
| diffusor, mesh 3d, quality |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
| [snappyHexMesh] sHM layer process keeps getting killed | MBttR | OpenFOAM Meshing & Mesh Conversion | 4 | August 15, 2016 03:21 |
| [ICEM] Heart modeling - ICEM Hexa Mesh quality improvement | heart_modeller | ANSYS Meshing & Geometry | 1 | April 8, 2016 08:16 |
| Mesh Quality good or bad? | RealENG22 | FLUENT | 5 | September 8, 2013 07:36 |
Linear Mode
