[ICEM] Error converting Pre Mesh to Unstructured Mesh

pizzaspinate · December 26, 2017, 14:18

Hi guys,

I'm trying to convert my Pre-Mesh to unstructrued mesh. When doing so the following error message occurs:

writing hexahedra... error writing fileI://hex.uns: element type out of rangeelement type out of range

I have never come across this and have no idea were the issue lies.

Could anyone help me out please?

shereez234 · December 29, 2017, 06:40

This is a weird error. Never seen it as well. Did you try opening ICEM again and trying this

sidharthm18 · October 1, 2019, 09:19

did you find solution to this. i am facing the same

Tianbao · March 24, 2020, 05:06

Exactly the same problem, anyone has solution?

December 26, 2017, 14:18	Error converting Pre Mesh to Unstructured Mesh	#1
pizzaspinate Member Join Date: Dec 2012 Posts: 81 Rep Power: 14	Hi guys, I'm trying to convert my Pre-Mesh to unstructrued mesh. When doing so the following error message occurs: writing hexahedra... error writing fileI://hex.uns: element type out of rangeelement type out of range I have never come across this and have no idea were the issue lies. Could anyone help me out please?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 08:38
Gambit problems	Althea	FLUENT	22	January 4, 2017 04:19
[ICEM] 2D profile unstructured mesh	h3nn3	ANSYS Meshing & Geometry	2	June 17, 2015 11:09
Mesh motion with Translation & Rotation	Doginal	CFX	2	January 12, 2014 07:21
unstructured vs. structured grids	Frank Muldoon	Main CFD Forum	1	January 5, 1999 11:09

December 29, 2017, 06:40		#2
shereez234 Senior Member M Sereez Join Date: Jan 2014 Location: England Posts: 353 Blog Entries: 1 Rep Power: 14	This is a weird error. Never seen it as well. Did you try opening ICEM again and trying this

October 1, 2019, 09:19		#3
sidharthm18 New Member Sidharath Madaan Join Date: Apr 2018 Posts: 3 Rep Power: 8	did you find solution to this. i am facing the same

March 24, 2020, 05:06		#4
Tianbao New Member China Join Date: May 2017 Location: Aalborg University Posts: 2 Rep Power: 0	Exactly the same problem, anyone has solution?