|
[Sponsors] |
[ICEM] error when writing large mesh file (>4GB) |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 7, 2018, 16:39 |
error when writing large mesh file (>4GB)
|
#1 |
New Member
Vincent Lee
Join Date: Jul 2017
Posts: 1
Rep Power: 0 |
Hello everyone, I encountered an error when ICEM outputs the .msh file, specifically when the file size reaches 4.19GB while it's still in the writing process. The same error always occur at 4.19GB, regardless of the of the mesh size. I've successfully output file sizes smaller than that.
The error just says "error writing to file", without further description of the error (see attached image). I'm not sure if this error has to do with memory limitation in ANSYS. I'm running the ICEM software on a school virtual desktop (28GB RAM) and writing the file to my personal laptop via Citrix Receiver. Any ideas or suggestions? Thanks all |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OpenFoam "Permission denied" and "command not found" problems. | iyidaniel@yahoo.co.uk | OpenFOAM Running, Solving & CFD | 11 | January 2, 2018 06:47 |
[mesh manipulation] Importing Multiple Meshes | thomasnwalshiii | OpenFOAM Meshing & Mesh Conversion | 18 | December 19, 2015 18:57 |
[snappyHexMesh] crash sHM | H25E | OpenFOAM Meshing & Mesh Conversion | 11 | November 10, 2014 11:27 |
[swak4Foam] build problem swak4Foam OF 2.2.0 | mcathela | OpenFOAM Community Contributions | 14 | April 23, 2013 13:59 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |