|
[Sponsors] |
[DesignModeler] How to create only a portion of ellipse |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 15, 2018, 23:56 |
How to create only a portion of ellipse
|
#1 |
New Member
Peewit Monkul
Join Date: Jan 2018
Posts: 2
Rep Power: 0 |
Hi everyone
I've a problem to draw an ellipse with the tangent line as shown in the figure. Suggest me how to do this, please. Thank you for your kind suggestions. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
create the file *.foam | phongstar | OpenFOAM | 12 | October 14, 2018 18:06 |
OpenFoam "Permission denied" and "command not found" problems. | iyidaniel@yahoo.co.uk | OpenFOAM Running, Solving & CFD | 11 | January 2, 2018 06:47 |
[gmsh] How to create a 3D volume mesh using a existing surface mesh?! | RobertHB | Mesh Generation & Pre-Processing | 0 | July 20, 2017 08:12 |
[ICEM] how to create a 2d tri mesh with quad mesh in the boundary layer | seal2013 | ANSYS Meshing & Geometry | 3 | October 6, 2013 16:09 |
[GAMBIT] 2D ellipse in rectangular domain | rieuk | ANSYS Meshing & Geometry | 8 | October 7, 2010 08:52 |