Modify radius ICEM
 

Hello, I have created a stepcylinder mesh in ICEM and I would like to do a couple of simulations with different cylinder radiuses. Is there any way to modify the cylinder radius with out doing it from scratch again?

Kind regards
Mathia

yes
 

Hi;

It is possible.

Go to transform blocking. select the blocks of cylinder ( if they are deleted recover them from VORFN). scale the blocks and while doing this select transform geometry as well ( and select the cylinder).

That should get you where you need.

Cheers
MS

Watch this video.

https://www.youtube.com/watch?v=UgEKoVXrYeg