I wanna control this territory
1 Attachment(s)
Hello,
You can see large difference through circumference wise. I want to decrease mesh size of this part. tell me your tip~ Have a nice day!! |
1) Hide "show mesh" item
2) Choose a Layer and enable at least "Master Topology Visibility" -> you should see purple lines at the layer 3) Hit right-mouse button on a line close to where you want to change the mesh size 4) Use "Edge Split Control" and assign a factor by which you want to increase the number of cells (can be decrease as well) |
I have a question.
Quote:
Thanks your reply. I have a question one more. I use ATM. Where is "Master Topology Visibility" ? To my knowledge, this is manual mode and ATM is strongest mode in TurboGrid. right? Have a nice day!! |
1 Attachment(s)
I tested it and it works just as I described.
Master Topology can be enabled in the respective Layer properties. Double click a layer and it should be in the window opening to the left. ATM is not "the strongest" mode, its just one of two options. It also has disadvantages, but in general gives high quality mesh. The purple lines in the image are the master topology lines. Right mouse click on them allows you to add a edge split control item to any line. |
Thank you!!
Quote:
But, It's not easy~ I'll try to get mesh of good quality. Thanks again. Have a nice day!! |
I think its pretty easy ... however, glad I could help.
|
All times are GMT -4. The time now is 06:02. |