 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] Axis-symmetric sweep with inflation and face matching |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 23, 2018, 00:17
|
Axis-symmetric sweep with inflation and face matching
|
#1 |
|
New Member
São Paulo
Join Date: May 2018
Posts: 2
Rep Power: 0  |
Hello fellow cfx users,
I am trying to mesh an axis-symmetric geometry with inflation layers near an edge. In order to enforce symmetry, I sweep method with 1 division. The inflation layers also work, when setup at the source face. However, at the target face, the elements no longer match those of the source face. I would appreciate any advice from anyone here. Thanks ^^ |
|
|
|
|
|
| Tags |
| axis-symmetric, face matching, inflation, symmetry |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] Inflation in Mapped Face Meshing | gill11a | ANSYS Meshing & Geometry | 13 | August 28, 2022 12:26 |
| Mapped face meshing confliction with inflation on multizone | nashim.chowdhury | FLUENT | 0 | April 18, 2017 21:56 |
| [ANSYS Meshing] inflation on the face other than source face of sweep meshing? | jayash | ANSYS Meshing & Geometry | 0 | April 16, 2014 04:11 |
| [ANSYS Meshing] Cutcell + inflation - problem with inlet face | blowback | ANSYS Meshing & Geometry | 2 | March 26, 2014 02:18 |
| [ANSYS Meshing] Inflation on common Face using cutcell mesh | foamcfd | ANSYS Meshing & Geometry | 0 | July 31, 2012 08:20 |
Linear Mode
