Problem in generating mesh
 

Hi,


I am new in Ansys Workbench. According the following figure, I don't know that why top face (Face meshing 3) is not mapped.





http://uupload.ir/files/sx55_2.png




http://uupload.ir/files/vnbv_1.png



I am grateful that guide me in this case. The ansys File (workbench) is as follows:


http://www.mediafire.com/file/6895iw...hout+slice.rar


Another question:


How can I change number of cell inside Holes? For this work, Should i project a edge on these holes?


Thanks.