 |
 |
 |
|
|
|
[Sponsors] | ||||
July 23, 2018, 08:38
|
2D Axissymmetric mesh
|
#1 |
|
New Member
Avinash
Join Date: May 2018
Posts: 2
Rep Power: 0  |
Dear Friends
I have created 2D mesh in ICEM. Also I have created a line called" Axis" which is aligned to x-Axis. In order to make it axis symmetric what is the next operation I need to perform in ICEM? For example, suppose I want to model a 2D cylinder. I create rectangular plane and bottom line would be defined as axis. after meshing what is the next step to do to make it axissymmetric. I have tried manuals and videos but could not find anything on it Thanks a lot for your time. Last edited by avinashcfd; August 9, 2018 at 10:33. |
|
|
|
|
 |
| Tags |
| axis symmetry, axis-symmetric |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Add Mesh Layers doesnt work on the whole surface | Kryo | OpenFOAM Meshing & Mesh Conversion | 13 | February 17, 2022 07:34 |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
| decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
| [Other] conformed FSI mesh for unstructured fluid region | ashish.svm | OpenFOAM Meshing & Mesh Conversion | 10 | August 2, 2019 08:40 |
| [ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
Linear Mode
