I get different boundary condition after translating to fluent
 

Good afternoon, Guys
Just tried to make a triangle and Meshed it using Ansys Meshing and used Named-Space to have different Boundary Condition(BC) and zones. Here is a screenshot that shows my "Cell zone shot"s in Ansys Meshing


http://uupload.ir/files/fra_2.png


And a screenshot that shows my BCs in Ansys Meshing


http://uupload.ir/files/4j4s_3.png


So finally when I translate it to fluent I get different BCs. Here is a screenshot of what I'm saying


http://uupload.ir/files/ni3i_5.png


While my Cell zone conditions are correct. Here is a screenshot on the cell zone conditions


http://uupload.ir/files/m0qg_4.png

What's going on? That's not the end of the story! When I try to do the initialization I get this error


http://uupload.ir/files/soa2_6.png


Any idea would be appreciated!

Guys,
What I'm doing is just trying to create three zone but it failed. Any idea to create three zone in a domain?

Any idea, hint,....?


Do you know any place to ask my question?

Why not try the fluent forum?
My preferred solver is CFX. What if you import it into CFX-Pre?
(I try to avoid fluent as much as possible).

Thank you for response,
Going to make another thread in the fluent forum.
I always use Fluent because it's well known.