Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[ANSYS Meshing] Creating a Moving Heat Source in order to simulate a Laser

Updated Threads

Reply

Search this Thread

August 28, 2018, 10:39	Creating a Moving Heat Source in order to simulate a Laser	#1
Lancer_21 New Member Eric Manch Join Date: Aug 2018 Posts: 1 Rep Power: 0	I am trying to generate a simulation of the Laser Cladding Process for my dissertation. Laser Cladding consists of having a powder material layered on top of a substrate, followed by providing heat through a laser as two melt both metals and mix them together. So far I have created Heat Flow on a sheet of material, by using tabular substeps, and am wondering if this is the right approach? Or is there an alternative way of generating a Laser heat source in ANSYS?

Reply

Tags

ansys, heat source, moving heat source, thermodynamic

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Ansys Workbench moving heat source and laser cladding?	eap88	ANSYS	1	April 27, 2016 01:30
what is swap4foam ??	AB08	OpenFOAM	28	February 2, 2016 01:22
Compressor Simulation using rhoPimpleDyMFoam	Jetfire	OpenFOAM Running, Solving & CFD	107	December 9, 2014 13:38
OpenFOAM without MPI	kokizzu	OpenFOAM Installation	4	May 26, 2014 09:17
"parabolicVelocity" in OpenFoam 2.1.0 ?	sawyer86	OpenFOAM Running, Solving & CFD	21	February 7, 2012 11:44

All times are GMT -4. The time now is 21:30.