|
[Sponsors] |
![]() |
![]() |
#1 |
Member
Marcello Asciolla
Join Date: Apr 2018
Location: Italy
Posts: 43
Rep Power: 8 ![]() |
I noticed that there is the "small sliding" option when I create a contact under connection in ANSYS Mesh module.
Can you explain what does this option do and when should I use it? I read something, but I am not sure I have understood its behavior. Interfaccia.JPG |
|
![]() |
![]() |
![]() |
![]() |
#2 |
New Member
Tom David
Join Date: May 2017
Posts: 17
Rep Power: 9 ![]() |
||
![]() |
![]() |
![]() |
Tags |
connection, contact, mesh, sliding, small |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Sliding Interface issues | philippose | OpenFOAM Running, Solving & CFD | 7 | May 5, 2014 04:13 |
[Other] An appropriate Mesher for creating sliding interface | sasanghomi | OpenFOAM Meshing & Mesh Conversion | 2 | May 5, 2013 16:24 |
why did Time step is too small in stiffbs? | satum | FLUENT | 1 | December 10, 2012 10:15 |
sliding mesh, confused me, help! help! | weiyang1980 | FLUENT | 2 | September 30, 2009 22:45 |
Intersecting sliding interface | jaswi | OpenFOAM Running, Solving & CFD | 0 | February 15, 2008 01:07 |