[GAMBIT] Sweep Problem

acalado · September 14, 2018, 10:43

Greetings,

I am having some issues with Gambit:

For some reason when I try doing a sweep of a face to create the volume, the rendered volume does not seem to match the edge lines (in green - see pic)

If you have any idea why this is happening I would appreciate your help.

Thanks!

-mAx- · September 17, 2018, 05:44

This is only a rendering
Mesh your volume and check if you still have this "distorsion" along the mesh.
If yes, I would suggest you to do some spit along the "extrusion"-edge
I remember I had such problem by "long" sweeps

acalado · September 17, 2018, 16:02

Thanks for the reply.

I split up the volume in to smaller pieces and it apparently solved the issue.

September 17, 2018, 05:44		#2
-mAx- Super Moderator Maxime Perelli Join Date: Mar 2009 Location: Switzerland Posts: 3,297 Rep Power: 41	This is only a rendering Mesh your volume and check if you still have this "distorsion" along the mesh. If yes, I would suggest you to do some spit along the "extrusion"-edge I remember I had such problem by "long" sweeps __________________ In memory of my friend Hervé: CFD engineer & freerider

September 17, 2018, 16:02		#3
acalado Senior Member André Join Date: Mar 2016 Posts: 133 Rep Power: 10	Thanks for the reply. I split up the volume in to smaller pieces and it apparently solved the issue. __________________ Sapere aude!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Convergence Problem in Multiphase problem (three phases)	m.uzair	FLUENT	0	August 2, 2018 08:23
UDF compiling problem	Wouter	Fluent UDF and Scheme Programming	6	June 6, 2012 04:43
natural convection problem for a CHT problem	Se-Hee	CFX	2	June 10, 2007 06:29
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 19:13
Is this problem well posed?	Thomas P. Abraham	Main CFD Forum	5	September 8, 1999 14:52