|
[Sponsors] |
September 19, 2018, 03:23 |
Boundary Layer Mesh
|
#1 |
Senior Member
Join Date: Aug 2012
Posts: 268
Rep Power: 14 |
I have created mesh around a blade. According to tutorials, at least 10 nodes must be placed in boundary layer to cover viscous sub-layer.
Does the arrow on the photo show the location where boundary layer ends or the boundary layer ends in a different location? Have I placed at least 10 nodes correctly? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
Radiation in semi-transparent media with surface-to-surface model? | mpeppels | CFX | 11 | August 22, 2019 07:30 |
Basic Nozzle-Expander Design | karmavatar | CFX | 20 | March 20, 2016 08:44 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
An error has occurred in cfx5solve: | volo87 | CFX | 5 | June 14, 2013 17:44 |