|
[Sponsors] |
[ANSYS Meshing] How to meshing multi small tubes in a large domain ?? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 18, 2018, 03:31 |
How to meshing multi small tubes in a large domain ??
|
#1 |
New Member
Sumit Peh
Join Date: Oct 2018
Location: Beijing
Posts: 20
Rep Power: 7 |
Hi all,
How to meshing multi small tubes in a large domain ?? In my thought, if meshing multi small tubes as a coarse mesh, it will reduce the element nodes and reduce the simulation time. (I'm focusing on the fluid domain flow pattern, small tubes just the flow inlet through the reactor) Thank you James |
|
October 27, 2018, 13:13 |
|
#2 |
Senior Member
sunil
Join Date: Jul 2012
Location: Bangalore
Posts: 179
Rep Power: 13 |
Two way we can mesh, you can use multizone settings for small holes or sweep mesh.
__________________
Regards, Sunil |
|
October 27, 2018, 22:58 |
|
#3 |
New Member
Sumit Peh
Join Date: Oct 2018
Location: Beijing
Posts: 20
Rep Power: 7 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Numerical precision in meshing large domains with small features | AeroIQ | Pointwise & Gridgen | 3 | January 20, 2017 11:38 |
Domain Imbalance | HMR | CFX | 5 | October 10, 2016 05:57 |
[ANSYS Meshing] Blocking and Meshing Strategy for an open flow domain over backward facing ramp | Crank-Shaft | ANSYS Meshing & Geometry | 0 | January 11, 2013 05:48 |
Multi flow in two different domain | arunss | CFX | 3 | May 11, 2010 16:06 |
meshing very small tubes | Wooster | CFX | 6 | July 23, 2007 10:41 |