 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] Interface in Cut Cell - Assembly meshing method |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 18, 2018, 09:32
|
Interface in Cut Cell - Assembly meshing method
|
#1 |
|
New Member
Czeczko
Join Date: Aug 2018
Posts: 2
Rep Power: 0  |
Hi,
I've used a cut cell meshing method to model a flow thorugh nozzle located in combustion chamber. The problem is that while using that meshing method I get no interfaces in Fluent. All contacts are present in Mesh aplication and I've tried promoting them to named selection and pair together, it doesn't work. Is it possible to create solid/fluid phase interface through Cell Cut meshing method? Thank You |
|
|
|
|
|
September 14, 2020, 08:05
|
|
#2 |
|
Member
Deutschland
Join Date: Jun 2020
Location: https://t.me/pump_upp
Posts: 43
Rep Power: 5    |
could you solve your problem?
I face the same issue |
|
|
|
|
|
|
| Tags |
| cutcell, interface |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
| How to use the CFX periodic interface | zhihuawan | CFX | 61 | January 15, 2018 16:20 |
| Journal file error | magicalmarshmallow | FLUENT | 3 | April 4, 2014 12:25 |
| Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
| Cartecian Cut Cell Method | DR.K.Thiruvenkatasamy | Main CFD Forum | 4 | January 29, 2007 06:18 |
Linear Mode
